Hyundai Elantra: Body (Interior and Exterior) / Floor Carpet. Repair procedures

Repair procedures

Replacement
   
•
Put on gloves to prevent hand injuries.
   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the floor console assembly.
(Refer to Floor Console - "Floor Console Assembly")
2.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
3.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
4.
Remove the cowl side trim.
(Refer to Interior Trim - "Cowl Side Trim")
5.
Remove the center pillar lower trim.
(Refer to Interior Trim - "Center Pillar Trim")
6.
Remove the footrest (A).
7.
Remove the floor carpet assembly (B).
8.
To intall, reverse the removal procedure.
   
•
Replace any damaged clips (or pin-type retainers).

1. Front floor carpet assembly
2. Footrest
3. Footrest bracket
4. Front tunnel pad

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: BJ Boot Repair procedures
Removal 1. Remove the front driveshaft. (Refer to Driveshaft Assembly - "Front Driveshaft") 2. Remove the TJ joint assembly. (Refer to Driveshaft Assembly - "TJ Joint") 3. Remove the Dynamic damper. (Refer to Driveshaft Assembly - "Dynamic Damper") 4. Using a plier or flat-tip ...

Hyundai Elantra AD (2016-2020) Service Manual: Audio Remote Control Repair procedures
Inspection 1. Check for resistance between terminals in each switch position (LH). [LH : Audio + Hands free] SwitchConnector terminalResistance(±5%)SEEK Up2-5430 ?SEEK Down1.11 k?MODE2.11 k?MUTE3.11 k?Volume (+)4.61 k?Volume (-)6.81 k?Voice10.71 k?SEND18.91 k?END40.91 k? 2. Check for re ...

© 2018-2026 www.helantraad.com