Hyundai Elantra: AVN System / External AMP Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Open the trunk, remove the right luggage side trim.
(Refer to Body - "Trunk Trim")
3.
Remove the external amplifier (B) after disconneting the connector (A) and loosening the mounting nuts.

Installation
1.
Install the external amplifier after connecting the connector.
2.
Install the right luggage side trim.
3.
Connect the negative (-) battery terminal.
   
•
Make sure that the cables and connectors are plugged in properly.
•
Check the AVN system.
External AMP Components and Components Location
Components NoConnector ANoConnector B1BATT (+)1Subwoofer 2 (+)2BATT (+)2Subwoofer 1 (+)3BATT (+)3Front door tweeter speaker - RH (+)4BATT (+)4Front door tweeter speaker - LH (+)5-5-6Multimedia CA ...

AVN Remote Controller Components and Components Location
Components 1. Left Remote Control Switch (Audio + Hands free)2. Right Remote Control Switch(Cruise+Trip Computer) ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Shift Lever Repair procedures
Removal 1. Pull the knob (A) in the direction of "F" and remove the knob. 2. Disconnect the connector (B) from the shift lever. 3. Disconnect the fixing clip (A) of wiring. 4. Disconnect the shift cable. (1) Remove the snap pin (A). (2) Disconnect the cable eye end (B) from t ...

Hyundai Elantra AD (2016-2020) Service Manual: Windshield Deicer
Components and Components Location Component Location Windshield deicer system prevent windshield wiper from freezing in the winter season. It consists of deicer in the lower part of windshield, switch and relay. Body control module receives an input signal from the front defroster switch, ...

© 2018-2026 www.helantraad.com