Hyundai Elantra: Airbag Module / Driver Airbag (DAB) Module and Clock Spring Description and Operation

Hyundai Elantra AD (2016-2020) Service Manual / Restraint / Airbag Module / Driver Airbag (DAB) Module and Clock Spring Description and Operation

Description
•
Driver Air Bag (DAB)
DAB is installed in the steering wheel, and electrically connected to the SRSCM via clock spring. It is deployed during frontal impact to protect the driver.
•
Clock Spring
Clock spring delivers actuation signal, generated by the sensors installed in the front and right/left sides of a vehicle, to the inflator (gas generator) of the driver air bag module via internal cable.
It also delivers actuation signal of the steering wheel remote control switch and horn to relevant systems via internal cable.
   
•
Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious personal injury.
Driver Airbag (DAB) Module and Clock Spring Components and Components Location
Components 1. Driver Air Bag (DAB)2. Steering Wheel3. Clock Spring ...

Driver Airbag (DAB) Module and Clock Spring Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the driver airbag module by putting in a flat tool (O5mm) into the guide h ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Troubleshooting
Standard Flow of Diagnostic Troubleshooting Notes With Regard To Diagnosis The phenomena listed in the following table are not abnormal. ConditionExplanationSystem check soundWhen starting the engine, a thudding sound can sometimes be heard coming from inside the engine compartment. This is bec ...

Hyundai Elantra AD (2016-2020) Service Manual: Body Side Molding
Delta Garnish Repair procedures Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Take care not ...

© 2018-2026 www.helantraad.com