Hyundai Elantra: Timing System / Drive Belt Tensioner Repair procedures

Removal and Installation
1.
Disconnect the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the drive belt tensioner (A).

Tightening torque :
center bolt : 29.4 ~ 41.2 N.m (3.0 ~ 4.2 kgf.m, 21.7 ~ 30.4 lb-ft)
fxing bolt : 39.2 ~ 49.0 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)

3.
Install in the reverse order of removal.
Drive Belt Tensioner Components and Components Location
Components 1. Drive belt tensioner ...

Crankshaft Damper Pulley Components and Components Location
Components 1. Crankshaft damper pulley ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Detecting Sensor. Warning message
The rear radars are located inside the rear bumper for detecting the side and rear areas. Always keep the rear bumper clean for proper operation of the system. NOTICE The system may not work properly when the bumper has been damaged, or if the rear bumper has been replaced or repaired. ...

Hyundai Elantra AD (2016-2020) Service Manual: Heater & A/C Control Unit (Manual) Components and Components Location
Components ConnectorPin NOFunctionConnectorPin NOFunctionA1LowB18ILL- (RHEO)2Common19Sensor ground3Ground20Ground4Middle Low21Battery (+)5Middle High22ISG DC6High23ISG B+B1IGN224ILL+ (TAIL)2PAB IGN125Sensor REF (+5V)3HTD (Rear defog indicator)26EVAP sensor (+)4Detent Out (-)27AMB sensor (+)5PTC ...

В© 2018-2026 www.helantraad.com