Hyundai Elantra: Interior Trim / Door Step Trim Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Interior Trim / Door Step Trim Repair procedures

Replacement

[Front door step trim]

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Using a screwdriver or remover, remove the front door step trim (A).

To intall, reverse the removal procedure.

•	Replace any damaged clips (or retainers or fasteners).

[Rear door step trim]

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Using a screwdriver or remover, remove the rear door step trim (A).

To intall, reverse the removal procedure.

•	Replace any damaged clips (or retainers or fasteners).

Door Step Trim Components and Components Location

Component 1. Front door step trim 2. Rear door step trim ...

Cowl Side Trim Components and Components Location

Component Location 1. Cowl side trim ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: System Maintenance
Climate control air filter This filter is installed behind the glove box. It filters the dust or other pollutants that enter the vehicle through the heating and air conditioning system. Have the climate control air filter replaced by an authorized HYUNDAI dealer according to the maintenance ...

Hyundai Elantra AD (2016-2020) Service Manual: Output Speed Sensor Repair procedures
Inspection 1. Using the GDS, check the input/output speed sensor waveforms. A. Turn OFF the ignition switch. B. Connect the GDS to the Data Link Connector(DLC) on the lower crash pad. C. Ignition "ON" & Engine "ON". D. Check the input/output speed sensor waveforms at high spe ...