Hyundai Elantra: Tire Pressure Monitoring System / Description and Operation

Hyundai Elantra AD (2016-2020) Service Manual / Suspension System / Tire Pressure Monitoring System / Description and Operation

Description

TREAD Lamp

-	Tire Under Inflation / Leak Warning.

Turn on condition

A.	When tire pressure is below allowed threshold

B.	When rapid leak is detected by the sensor.

C.	Indicates that tire needs to be re-inflated to placard pressure / repaired.

Turn off condition

A.	Under-inflation ; When tire pressure is above (warning threshold + hysteresis).

B.	Rapid Leak ; When tire pressure is above (leak warning threshold).

DTC Warning

Turn on condition

A.	When the system detects a fault that is external to the receiver/ sensor.

B.	When the system detects a receiver fault.

C.	When the system detects a sensor fault.

Turn off condition

If the fault is considered as 'critical', then the lamp is held on throughout the current Ignition cycle (even if the DTC has been demoted). This is because it is important to bring the problem to the drivers attention. On the following Ignition cycle, the demotion conditions will be re-checked. If the demotion conditions occur, the lamp will be turned off. It will be held on until DTC demotion checking is completed.

B.	'Non critical' faults are those that can occur temporarily e.g. vehicle battery under voltage. The lamp is therefore turned off when the DTC demotion condition occurs.

System Fault

General Function

A.	The system monitors a number of inputs across time in order to determine that a fault exists.

B.	Faults are prioritized according to which has the most likely cause.

C.	Maximum fault store is equal to 15.

D.	Certain faults are not covered through DTC. The main ones are :

1)	Sensor thermal shutdown (over 257 °F/ 125 °C).

2)	Ignition Line stuck ; requires observation of lamps at Ignition ON to diagnose.

Components and Components Location

Components 1. Body control module(BCM)2. TPMS sensor (FL)3. TPMS sensor (RL)4. TPMS sensor (FR)5. TPMS sensor (RR) ...

TPMS Sensor Description and Operation

Description 1. General description WU is a sensor placed in the tire that reports pressure and temperature. The WU is mounted inside the wheels, fixed to the valve. The angle between the valve ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Repair procedures
Operation and Leakage Check Check all of the following items: ComponentProcedureBrake Booster (A)Check brake operation by applying the brakes during a test drive. If the brakes do not work properly, check the brake booster. Replace the brake booster as an assembly if it does not work properl ...

Hyundai Elantra AD (2016-2020) Service Manual: Water pump Troubleshooting
Troubleshooting SymptomsPossible CausesRemedyCoolant leakage • From the bleed hole of the water pump Visually check • Check leaks after about ten-minute warming up. • If coolant still leaks, replace a water pump. • If leakage stops, reuse the water pump (Do not repl ...