Hyundai Elantra: Engine Control System / CVVT Oil Control Valve (OCV) Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Engine Control/Fuel System / Engine Control System / CVVT Oil Control Valve (OCV) Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the OCV connector.

3.	Measure resistance between the OCV terminals 1 and 2.

Check that the resistance is within the specification.

Specification : Refer to "Specification"

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the CVVT oil control valve connector (A).

3.	Remove the installation bolt (B), and then remove the valve from the engine. [Bank 1 / Intake] #1 [Bank 1 / Intake] #2 [Bank 1 / Exhaust]

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

•	Apply engine oil to the valve O-ring.

Installation is reverse of removal.

CVVT oil control valve installation bolt :

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

CVVT Oil Control Valve (OCV) Schematic Diagrams

Circuit Diagram ...

Variable Intake Solenoid (VIS) Valve Description and Operation

Description Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The EC ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Head Lamps Repair procedures
Head Lamp Aiming Instructions [Mechanical Aiming] The head lamps should be aimed with the proper beam-setting equipment, and in accordance with the equipment manufacturer's instructions. • If there are any regulations pertinent to the aiming of head lamps in the ...

Hyundai Elantra AD (2016-2020) Service Manual: Components and Components Location
Components Location 1. Steering wheel2. Steering column3. MDPS ECU4. MDPS motor5. Tie rod end6. Bellows7. Steering gear box8. Dust cover9. Universal joint ...