Hyundai Elantra: Airbag Module / Curtain Airbag (CAB) Module Description and Operation
Curtain airbags are installed inside the headliner (LH and
RH) and protect the driver and passenger from danger when side crash
occurs. The SRSCM determines deployment of curtain airbag by using side
impact sensor (SIS) signal.
| • |
Never attempt to measure the circuit resistance of the airbag
module even if you are using the specified tester. If the circuit
resistance is measured with a tester, accidental airbag deployment will
result in serious personal injury. |
|
Components
1. Curtain Air Bag (CAB)
...
Removal
1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the roof trim.
(Refer to Body - "Roof Trim Assembly")
3.
Remove the curt ...
Other information:
Hyundai Elantra AD (2016-2020) Owners Manual: Driver Assist System
Rear View Monitor
The Rear View Monitor will activate when the engine is running and the shift
lever is in the R (Reverse) position.
This is a supplemental system that provides a view of the area behind the vehicle
through the display audio or AVN screen while the vehicle is in the R (Reve ...
Hyundai Elantra AD (2016-2020) Service Manual: Description and Operation
Description
BSD is a system that uses two magnetic wave radar sensors
attached on the rear panel to measure the distance from the following
vehicles and provides the sensing and (visual and auditory) alarm of any
vehicle coming into the blind spot.
-
Blind Spot Detection (BSD) : Senses o ...
Curtain Airbag (CAB) Module Components and Components Location
Curtain Airbag (CAB) Module Repair procedures