Hyundai Elantra: Interior Trim / Cowl Side Trim Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Interior Trim / Cowl Side Trim Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the front door scuff trim. (Refer to Interior Trim - "Door Scuff Trim")

2.	Remove the hood latch release handle. (Refer to Hood - "Hood Latch Release Handle")

3.	Carefully remove the front door body side weatherstrip.

4.	Using a screwdriver or remover, remove the cowl side trim (A).

To intall, reverse the removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Cowl Side Trim Components and Components Location

Component Location 1. Cowl side trim ...

Front Pillar Trim Components and Components Location

Component Location 1. Front pillar trim ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Limitations of the System
The driver must be cautious in the below situations because the system may not detect other vehicles or objects in certain circumstances: The vehicle is driven in inclement weather such as heavy rain or snow. The sensor is polluted with rain, snow, mud, etc. The rear bumper where the senso ...

Hyundai Elantra AD (2016-2020) Service Manual: Immobilizer Control Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the main crash pad assembly. (Refer to Body - "Main Crash Pad Assembly") 3. Discnnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening a nut. Installation 1. Install the ...