Hyundai Elantra: Roof Trim / Assist Handle Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Roof Trim / Assist Handle Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

•	Take care not to bend or scratch the trim and panels.

1.	After lifting up the assist handle caps and loosening the mounting screws, remove the assist handle (A).

2.	To intall, reverse the removal procedure.

Assist Handle Components and Components Location

Component Location 1. Assist handle ...

Roof Trim Assembly Components and Components Location

Component Location 1. Roof Trim Assembly ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check that the ...

Hyundai Elantra AD (2016-2020) Service Manual: Starter Relay Repair procedures
Inspection 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the fuse box cover. 3. Remove the starter relay (A). 4. Using an ohmmeter, check that there is continuity between each terminal. TerminalContinuity30 - 87NO85 - 86YES 5. Apply 12V ...