Hyundai Elantra: Engine Control System / Accelerator Position Sensor (APS) Description and Operation

Hyundai Elantra AD (2016-2020) Service Manual / Engine Control/Fuel System / Engine Control System / Accelerator Position Sensor (APS) Description and Operation

Description

Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line. The second sensor monitors the first sensor and its output voltage is half of the first one. If the ratio of the sensor 1 and 2 is out of the range (approximately 1/2), the diagnostic system judges that it is abnormal.

Heated Oxygen Sensor (HO2S) Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S terminals 2 and 5 [B1/S1]. Measure resistance between the HO2S termina ...

Accelerator Position Sensor (APS) Specifications

Specification AcceleratorPositionOutput Voltage (V)APS1APS2C.T0.7 ~ 0.80.325 ~ 0.425W.O.T3.98 ~ 4.221.93 ~ 2.17 ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Electric Thermostat (ECT) Components and Components Location
Components 1. Water inlet fitting & Thermostat2. Bypass hose3. Heater pipe & hose assembly ...

Hyundai Elantra AD (2016-2020) Service Manual: Smart Cruise Control Unit Description and Operation
Description The smart cruise control unit is installed on the front of the chassis.A radar sensor is embedded in the front section of the unit. This sensor detects vehicles and objects in front of the vehicle. The alarm goes off when the vehicle deviates from the horizontal and vertical a ...