Hyundai Elantra: Driver Attention Warning (DAW) System / System Standby

Hyundai Elantra. System Standby

The Driver Attention Warning (DAW) system enters the ready status and displays the 'Standby' screen in the following situations.

- The system is unable to collect data to monitor the driver's driving conditions.
- Driving speed remains under 40 mph (64 km/h) or over 110 mph (177 km/h).

Resetting the System
The last break time is set to 00:00 and the driver's attention level is set to 5 (very attentive) when the driver resets the Driver Attention Warning (DAW) system. The Driver Attention ...

System Malfunction
Check Driver Attention Warning (DAW) system When the warning message appears, the system is not working properly. In this case, have the vehicle inspected by an authorized HYUNDAI dealer. WARNIN ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Brake Pedal Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the stop lamp switch connector (A). 4. Remove the wiring fixed clip from the brake pedal member. 5. Remove the bra ...

Hyundai Elantra AD (2016-2020) Service Manual: TJ Joint Repair procedures
Disassembly     • Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease. • The boot band should be replaced with a new one. 1. Remove the Front Driveshaft. (Refer to Driveshaft Assembly - "Front Driveshaft") ...

© 2018-2025 www.helantraad.com