Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Open the sunglass case cover from the overhead console and
remove the 2 screws holding the overhead console. Disconnect the switch
connector and Map lamp connector, and then remove the overhead console
lamp (A). |
3. |
Check for continuity between the terminals. |
Hyundai Elantra AD (2016-2020) Service Manual: Alternator Components and Components Location
Components
1. OAD (Overrunning Alternator Decoupler) 2. Front Bracket3. Front Bearing4. Stator5. Rotor6. Rear Bearing7. Rear Bracket8. Brush Holder Assembly9. Through Bolt10. Rectifier Assembly11. Rear Cover
...
Hyundai Elantra AD (2016-2020) Service Manual: Driver Airbag (DAB) Module and Clock Spring Repair procedures
Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the driver airbag module by putting in a flat tool (O5mm) into the guide hole and then press the spring.
3.
Release the connector locking pin, then disconnect the driver ...