Hyundai Elantra: General Information / Special Service Tools

Hyundai Elantra AD (2016-2020) Service Manual / Engine Mechanical System / General Information / Special Service Tools

Special Service Tools
Tool (Number and name)
Illustration
Use
Crankshaft front oil seal installer
09231-2E000

Installation of the front oil seal
Valve stem seal installer
09222-2E000

Installation of the valve stem oil seal
Valve spring compressor
A : 09222-3K000
B : 09222-2A100

Removal and installation of the intake or exhaust valve
Crankshaft rear oil seal installer
A : 09214-2E000
B : 09231-H1100

Installation of the rear oil seal
Ring gear stopper
A : 09231-2B100
B : 09231-3N100

Removal and installation of crankshaft pulley
bolt.
Ring gear stopper
A : 09231-3D100
B : 09231-2W100

Removal and installation of crankshaft pulley
bolt.
Torque angle adapter
09221-4A000

Installation of bolts & nuts needing an angular method of adjustment
Oil pan remover
09215-3C000
•
Removal of oil pan
•
Must use this tool to separate the oil pan from the lower crankcase assembly without damage to the sealing surfaces
Tensioner stopper pin
09240-2E100

Holding compressed piston of tensioner
Oil filter wrench
09263-2E000

Removal and installation of oil filter

Troubleshooting
Troubleshooting SymptionSuspect areaRemedyEngine misfire with abnormal internal lower engine noises • Worn crankshaft bearings • Loose or out of specification engine flywheel †...

Engine And Transaxle Assembly
...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: 35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check that the ...

Hyundai Elantra AD (2016-2020) Service Manual: Repair procedures
Removal     • Put on gloves to protect your hands.     • Use seat covers to avoid damaging any surfaces. 1. Remove the roof side molding. (Refer to Body Side Moldings - "Roof Side Molding") 2. Remove the package tray trim. (Refer to ...

© 2018-2025 www.helantraad.com