Hyundai Elantra: Interior Trim / Luggage Side Trim Repair procedures

Replacement
   
•
Put on gloves to prevent hand injuries.
   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear seat assembly
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Carefully remove the rear door body side weatherstrip.
3.
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
4.
Remove the rear transverse trim.
(Refer to Interior Trim - "Rear Transverse Trim")
5.
Loosen the mounting clips and screws, remove the luggage partition side trim (A).

6.
After loosening the mounting bolts and screws, remove the luggage side trim (A).

7.
To intall, reverse the removal procedure.
   
•
Replace any damaged clips (or pin-type retainers).
Luggage Side Trim Components and Components Location
Component Location 1. Luggage side trim ...

Rear Pillar Trim Components and Components Location
Component Location 1. Rear pillar trim ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Side Impact Sensor (SIS) Repair procedures
Removal Pressure Side Impact Sensor     • Removal of the airbag must be performed according to the precautions/procedures described previously. • Before disconnecting the side impact sensor connector(s), disconnect the side airbag connector(s). • Do not tur ...

Hyundai Elantra AD (2016-2020) Service Manual: SS-A Solenoid Valve(ON/OFF) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check that the ...

© 2018-2026 www.helantraad.com