Hyundai Elantra: Airbag Module / Knee Airbag (KAB) Module Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Restraint / Airbag Module / Knee Airbag (KAB) Module Repair procedures

Removal

1.	Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.

2.	Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel")

3.	Remove the knee airbag module (A) after loosening the mounting nuts.

4.	Disconnect the knee airbag module connector (A).

Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes.

Install the knee airbag module after connect the knee airbag module connector.

Tightening torque :

Bolt : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

4.	Install the crash pad lower panel.

5.	Reconnect the battery negative cable.

After installing the knee airbag (KAB), confirm proper system operation :

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Knee Airbag (KAB) Module Description and Operation

Description The Knee Airbag (KAB) is installed inside the crash pad lower panel and protects the driver in the event of a frontal crash. The SRSCM determines if and when to deploy the KAB. ...

Airbag Module Disposal Description and Operation

Airbag Disposal When you scrap a vehicle equipped with an airbag, you must deploy it first. When you deploy an airbag, you need to have a skilled mechanic do the work. The used airbag should no ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Power Brakes
Your vehicle has power-assisted brakes that adjust automatically through normal usage. If the engine is not running or is turned off while driving, the power assist for the brakes will not work. You can still stop your vehicle by applying greater force to the brake pedal than typical. The sto ...

Hyundai Elantra AD (2016-2020) Service Manual: Heater Unit Components and Components Location
Component Location 1. Heater unit assembly Compoents 1. Shower duct [LH]2. Heater core cover3. Heater core & Seal assembly4. Mode actuator5. Temperature control actuator [LH]6. PTC Heater7. Heater unit pad8. Air guide [LH]9. Heater case [LH]10. Evaporator core assembly11. Heater core ...