Hyundai Elantra: What To Do in an Emergency / If the Engine Will not Start
If the Engine Doesn't Turn Over or Turns Over Slowly
- Be sure the shift lever is in N (Neutral) or P (Park). The engine starts only when the shift lever is in N (Neutral) or P (Park).
- Check the battery connections to be sure they are clean and tight.
- Turn on the interior light. If the light dims or goes out when you operate the starter, the battery is drained.
Do not push or pull the vehicle to start it. This could cause damage to your vehicle. See instructions for "Jump Starting" provided in this chapter.
CAUTION
Push or pull starting the vehicle may cause the catalytic converter to overload which can lead to damage to the emission control system.
If the Engine Turns Over Normally but Doesn't Start
Check the fuel level and add fuel if necessary.
If the engine still does not start, have your vehicle checked by an authorized HYUNDAI dealer.
In Case of an Emergency While Driving
If the Engine Stalls While Driving
Reduce your speed gradually, keeping a straight line. Move cautiously off
the road to a safe place.
Turn on your hazard warning flasher.
Try to start the ...
Jump Starting
Jump starting can be dangerous if done incorrectly. Follow the jump starting
procedure in this section to avoid serious injury or damage to your vehicle. If
in doubt about how to properly jump sta ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Back View Camera System
Components and Components Location
Component Location
1. Back view camera2. AVN monitor
Schematic Diagrams
Circuit Diagram
Description and Operation
Description
Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.
...
Hyundai Elantra AD (2016-2020) Service Manual: Compressor Repair procedures
Removal
Precautions for using the plastic pulley
•
Take care not to give physical impact to the plastic pulley.
If exposed to the impact of dropping and collision, the pulley should not be used although not damaged.
•
Be careful not to place the pulley to dow ...
