Hyundai Elantra: Anti-lock Brake System (ABS) Warning Light, Electronic Brake Force Distribution (EBD) System Warning Light / Headlight Warning Light, LED Headlight Warning Light

Headlight Warning Light

Hyundai Elantra. Headlight Warning Light, LED Headlight Warning Light

This warning light illuminates:

This warning light illuminates if one of the exterior bulbs (headlamp, DRL, turn signal lamp, stop lamp, etc.) is not operating properly. One of the bulbs may need to be replaced. If the vehicle is equipped with LED headlamps, have the vehicle inspected by an authorized HYUNDAI dealer.

Information

When replacing the bulb, use the same wattage bulb.

For more details, refer to "BULB WATTAGE" in chapter 8.

LED Headlight Warning Light

Hyundai Elantra. Headlight Warning Light, LED Headlight Warning Light

This warning light illuminates:

This warning light blinks:

When there is a malfunction with a LED headlight related part.

If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.

NOTICE

Continuous driving with the LED Headlight Warning Light on or blinking can reduce LED headlight life.

Forward Collision Avoidance Assist Warning Light, Lane Keeping Assist (LKA) System Indicator Light
Forward Collision Avoidance Assist Warning Light (if equipped) This warning light illuminates : When you set the ignition switch or Engine Start/Stop button to the ON position. - It illuminat ...

Master, Door Ajar, Trunk Open, Hood Open Warning Lights Light
Master Warning Light This indicator light illuminates • When there is a malfunction in operation in any of the following systems: - Exterior lamp malfunction - Blind-Spot Collision Warning (BC ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Accelerator Position Sensor (APS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output voltage of the APS 1 and 2 at C.T and W.O.T. Specification : Refer to "Specification" ...

Hyundai Elantra AD (2016-2020) Service Manual: Roof Side Molding Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. 1. Using a screwdriver or remover, remove the roof ...

© 2018-2024 www.helantraad.com