Hyundai Elantra: Fuel Delivery System / Delivery Pipe Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Engine Control/Fuel System / Fuel Delivery System / Delivery Pipe Repair procedures

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

Release the residual pressure in fuel line.

(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")

•	When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of "Release Residual Pressure in Fuel Line" work.

3.	Disconnect the injector connector (A).

4.	Disconnect the fuel feed tube quick-connector (B).

5.	Remove the installation bolt (C), and then remove the delivery pipe & injector assembly from the engine.

Installation

Installation is reverse of removal.

Delivery pipe installation bolt :

18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

Accelerator Pedal Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (A) and ...

Automatic Transaxle System

...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Alternator Schematic Diagrams
Circuit Diagram • COM signal - When controlling the voltage generated, the ECM sends the target voltage data to the alternator via a PWM signal.(High voltage: 4V or higher, low voltage: 2V or lower) • FR signal - The transistor activation signal inside t ...

Hyundai Elantra AD (2016-2020) Service Manual: Stop Lamp Switch Schematic Diagrams
Schematic Diagram System circuit diagram Terminal function TeminalDescription1IGN12Engine Control Module (ECM)3B+4Stop Lmap ...