Hyundai Elantra: Cylinder Head Assembly / Cylinder Head Components and Components Location

Components

1. Camshaft bearing cap
2. Camshaft front bearing cap
3. Exhaust camshaft
4. Intake camshaft
5. Exhaust CVVT assembly
6. Intake CVVT assembly
7. Cam carrier
8. Cylinder head
9. Cylinder head gasket
10. Retainer lock
11. Retainer
12. Valve spring
13. Valve stem seal
14. Valve
15. Swing arm
16. Hydraulic lash adjuster (HLA)

CVVT & Camshaft Repair procedures
Removal     • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connector portion. ...

Cylinder Head Repair procedures
Removal Engine removal is not required for this procedure.     • Use fender covers to avoid damaging painted surfaces. • To avoid damaging the cylinder head, wait un ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspection. Test Conditions Symp ...

Hyundai Elantra AD (2016-2020) Owners Manual: Good Driving Practices
Never move the shift lever from P (Park) or N (Neutral) to any other position with the accelerator pedal depressed. Never move the shift lever into P (Park) when the vehicle is in motion. Be sure the vehicle is completely stopped before you attempt to shift into R (Reverse) or D (Drive) ...

© 2018-2026 www.helantraad.com