Hyundai Elantra: Cooling System / Cooling Fan Specifications

Specifications
Item
Specification
Fan type
Puller
Fan speed control
Resistor (HI-LOW-OFF)
Air flow rate [m?/h (yd?/h)]
1,950 -8% min.
Fan speed (rpm)
1,650 ± 8%
Current (A)
11.7 + 10% max.

Cooling Fan Components and Components Location
Components 1. Cooling fan2. Fan motor 3. Cooling fan shroud4. Cooling fan resistor ...

Cooling Fan Schematic Diagrams
Circuit Diagram ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspection. Test Conditions Symp ...

Hyundai Elantra AD (2016-2020) Owners Manual: Distributing the sealant
9. Immediately drive approximately 7~10 km (4~6 miles or, about 10min) to evenly distribute the sealant in the tire. Do not exceed a speed of 80 km/h (50 mph). If possible, do not fall below a speed of 20 km/h (12 mph). While driving, if you experience any unusual vibration, ride disturbance ...

© 2018-2023 www.helantraad.com