Hyundai Elantra: Blower / Blower Resistor (Manual) Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Heating, Ventilation and Air Conditioning / Blower / Blower Resistor (Manual) Repair procedures

Inspection

1.	Measure the resistance between the terminals.

2.	The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Remove the crash pad center panel. (Refer to Body - "Crash Pad Center Panel")

3.	Remove the passenger's side shower duct (A) after loosening the screw.

4.	Disconnect the connector (A) and then remove the blower resistor (B) after loosening the mounting screws.

5.	To intall, reverse the removal procedure.

Power Mosfet Repair procedures

Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage until high ...

Climate Control Air Filter Description and Operation

Description The climate control air filter is located in the blower unit. It eliminates foreign materials and odor. The particle filter performs a role as an odor filter as well as a conventio ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Repair procedures
Adjustment Glass Adjustment • Check the glass run channel for damage or deterioration, and replace it if necessary. 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Separate the mounting plug hole (A) from the front door module. ...

Hyundai Elantra AD (2016-2020) Service Manual: Fuel Line Repair procedures
Removal 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") 3. Disconnect the fuel feed quick-connector (A). 4. Disconnect the vapor hose (A) wh ...