Passengers should not move out of or change seats while the vehicle is moving.
A passenger who is not wearing a seat belt during a crash or emergency stop can be thrown against the inside of the vehicle, against other occupants, or be ejected from the vehicle.
Do not use any accessories on seat belts.
Devices claiming to improve occupant comfort or reposition the seat belt can reduce the protection provided by the seat belt and increase the chance of serious injury in a crash
Do not modify the front seats.
Modification of the front seats could interfere with the operation of the supplemental restraint system sensing components or side air bags.
Do not place items under the front seats.
Placing items under the front seats could interfere with the operation of the supplemental restraint system sensing components and wiring harnesses.
Do not cause impact to the doors.
Impact to the doors when the ignition switch is in the ON position may cause the air bags to inflate.
Modifications to accommodate disabilities.
If you require modification to your vehicle to accommodate a disability, contact the HYUNDAI Customer Connect Center at 800- 633-5151.
Adding equipment to or modifying your air bag equipped vehicle
If you modify your vehicle by changing your vehicle's frame, bumper system, front end or side sheet metal or ride height, this may affect the operation of your vehicle's air bag system.
Hyundai Elantra AD (2016-2020) Service Manual: Windshield Wiper-Washer Switch Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
If it is necessary to remove multifunction switch assembly, remove the steering wheel.
(Steering System - "Steering Wheel")
3.
Remove the steering column upper shrouds (A).
(Refer to Body - "Steering Column Shroud Panel")
4 ...
Hyundai Elantra AD (2016-2020) Service Manual: Line Pressure Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).
4.
Measure resistance between sensor signal terminal and sensor ground terminal.
5.
Check that the ...