Hyundai Elantra: General Information / Towing

Hyundai Elantra AD (2016-2020) Service Manual / General Information / Towing

General Information

If the vehicle needs to be towed, call a professional towing service. It is very dangerous to tow a vehicle with just a rope or chain.

Emergency Towing

There are three popular methods of towing a vehicle :

-	Flat-bed Towing The operator loads the vehicle on the back of truck. This is the best way to transport the vehicle.

-	Wheel Lift Towing The tow truck uses two pivoting arms that go under the tires of the driving axle and lift them off the ground. The other two wheels remain on the ground.

Towing with slings

The tow truck uses metal cables with hooks on the ends. These hooks go around parts of the frame or suspension, and the cables lift that end of the vehicle off the ground. The vehicle's suspension and body can be seriously damaged if this method of towing is attempted.

If the vehicle cannot be transported by the flat-bed towing, it should be towed with the wheels of the driving axle off the ground.

Manual Transaxle

•	Release the parking brake.

•	Shift the Transaxle to neutral

Automatic Transaxle

•	Release the parking brake.

•	Start the engine.

•	Shift to [D] position, then [N] position.

•

Turn off the engine.

•	The vehicle equipped with full-time 4WD should be only transported on a flat-bed.

•	Improper towing preparation will damage the transaxle. Follow the procedure above exactly. If you cannot shift the transaxle or start the engine(automatic transaxle), your vehicle must be transported on a flatbed.

•	It is the best to tow vehicle no farther than 30km (19miles), and keep the speed below 50km/h (30mph). (For the full-time 4WD vehicle, limit the towing distance to 1.5km (1mile) and 15km/h (10mph)

•	Trying to lift or tow your vehicle by the bumpers will cause serious damage to the vehicle. The bumpers are not designed to support the vehicle's weight.

Front :

Rear :

Towing when ECS malfunctions

If the ECS malfunction indicator illuminates when there is no air in the suspension, the vehicle height will become low, so do not drive to protect the vehicle from the projections on the surface of the ground. The vehicle should be only transported on a flat-bed.

Take your vehicle to an authorized HYUNDAI dealer by towing the vehicle and have the system checked.

•	When you load the vehicle onto the tow truck, the loading angle should be smaller than 6°.

•	If a disabled vehicle is immobile, do not forcibly continue the towing.

Lift And Support Points

General Information • When heavy rear components such as suspension, fuel tank, spare tire, tailgate and trunk lid are to be removed, place additional weight in the l ...

General Tightening Torque Table

General Information BOLT (Nominal diameter)NUT (Nominal diameter) BOLT/NUT Thin screw Torque Nm (kg.m, Ib-ft) Nominal diameter. (mm)Pitch [mm (in.) ]4T8T10TM50.8 (0.031) 2.0 ~ ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Engine Coolant Temperature Sensor (ECTS) Description and Operation
Description Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant passage of the cylinder head for detecting the engine coolant temperature. The ECTS uses a thermistor whose resistance changes with the temperature. The electrical resistance of the ECTS decreases as the ...

Hyundai Elantra AD (2016-2020) Service Manual: Fuel Tank Air Filter Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the battery negative (-) terminal. 2. Remove the canister assembly. (Refer to Emission Control System - "Canister") 3. Remove the installation bolt (A), and then remove the air filter (B). 4. Release the lever (A), and then separa ...