Hyundai Elantra: Key Ignition Switch / Key ignition switch positions
LOCK
To turn the ignition switch to the LOCK position, put the key in at the ACC position and turn the key towards the LOCK position. The ignition key can be removed in the LOCK position. (The shift lever must be in the P (Park) position for Intelligent Variable Transmission (IVT)/dual clutch transmission vehicles)
ACC
Electrical accessories are usable. The steering wheel unlocks.
ON
This is the normal key position when the engine has started. All features and accessories are usable. The warning lights can be checked when you turn the ignition switch from ACC to ON.
Do not leave the ignition switch in the ON position when the engine is not running in order to prevent the battery from discharging.
START
To start the engine, turn the ignition switch to the START position. The switch returns to the ON position when you let go of the key.
The engine will crank until you release the key.
Key Ignition Switch
WARNING
To reduce the risk of SERIOUS INJURY or DEATH, take the following precautions:
NEVER allow children or any person who is unfamiliar with the vehicle
to touch the ignition switch or rel ...
Starting the engine
WARNING
Always wear appropriate shoes when operating your vehicle.
Unsuitable shoes, such as high heels, ski boots, sandals, flipflops, etc., may
interfere with your ability to use the brake and a ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: TJ Joint Repair procedures
Disassembly
•
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
•
The boot band should be replaced with a new one.
1.
Remove the Front Driveshaft.
(Refer to Driveshaft Assembly - "Front Driveshaft") ...
Hyundai Elantra AD (2016-2020) Service Manual: Output Speed Sensor Repair procedures
Inspection
1.
Using the GDS, check the input/output speed sensor waveforms.
A.
Turn OFF the ignition switch.
B.
Connect the GDS to the Data Link Connector(DLC) on the lower crash pad.
C.
Ignition "ON" & Engine "ON".
D.
Check the input/output speed sensor waveforms at high spe ...
