Hyundai Elantra: Fuel Delivery System / Filler-Neck Assembly Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Engine Control/Fuel System / Fuel Delivery System / Filler-Neck Assembly Repair procedures

Removal

1.	Remove the rear-LH wheel, tire, and the inner wheel house.

2.	Disconnect the fuel filter hose (A) and the ventilation hose (B).

3.	Open the fuel filler door and unfasten the filler-neck assembly mounting screw (A).

4.	Remove the filler-neck assembly from the vehicle after removing the bracket mounting bolts (A).

Installation

Installation is reverse of removal.

Filler-neck assembly bracket installation bolt :

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Fuel Line Repair procedures

Removal 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel ...

Accelerator Pedal Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (A) and ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Smart Cruise Control Unit Specifications
Specification ItemSpecificationPower supply(V)12Operation voltage (V)9 ~ 16 ...

Hyundai Elantra AD (2016-2020) Service Manual: Ignition System
Description and Operation Description Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module). The engine operating ...